Mitsubishi GOT2000 Series User Manual page 441

(4) LCPU
Item
Parameter Parameter to operate the PLC
Intelligent function
Parameter for the intelligent function module
module parameter
Program Program for the operation by the CPU (including SFC)
Device comment Device comment to be stored to the PLC
Boot setting file Batch file to start a program from the ROM or others
Device initial value Initial value setting of devices
*1
File register data
File register
Sampling trace data to collect the specified device data
*2
Sampling trace file
continuously at the specified timing
Programmable controller
Data created by users and stored to the memory card
user data
File for storing device
Device data that the SP.DEVST and S.DEVLD instructions use
data
Drive headline sentence Drive headline sentence
Remote password Remote password setting
Monitor sequence
Data to speed up the monitoring from other stations
extension
The file where the backup data is stored by the latch data backup
Latch data backup file
function to the standard ROM
Data logging setting file Data logging setting
Menu definition file Menu definition file
*1 The file register in the Flash card installed to the CPU is always restored and overwritten without any notice.
*2 Whether to restore or not to restore the file register in the SRAM card or the standard RAM can be selected in the dialog box
displayed when the restoration is executed.
*3 When the file register is not restored, the existing file register is deleted and the program of the controller may not operate
properly.
When a problem occurs in the operation of the controller after the restoration, restore the data including the file register again.
*4 Only the backup operation is available.
(5) FXCPU
Item
Parameter Parameter to operate the PLC
Device comment Device comment to be stored to the PLC
Sequence program Program for the operation by the CPU
*1
Positioning setting/Initial value parameter
Special program
File register File register data
*2
Extension file register data
Extension file register
Built-in CC-Link/LT
CC-Link/LT parameter
*3
setting
Parameter for special adaptors and special blocks stored in the
*1
Special parameter
main unit
*1 The backup and restoration can be performed only when the FX3U(C) or FX3G(C) series is used.
*2 The backup and restoration can be performed only when the FX3U(C) series is used.
*3 This data exists only in the FX3U-32MT-LT-2.
Description
Description
15.8 Backup and Restoration
File name
PARAM.QPA
IPARAM.QPA
***.QPG
***.QCD
AUTOEXEC.QBT
***.QDI
***.QDR
***.QTD
***.*** (Any name)
DEVSTORE.QST
QN.DAT
00000000.QTM
MONITOR.Q0*
LCHDAT00.QBK
LOGCOM.QLG
LOG01.QLG to
LOG10.QLG
MENUDEF.QDF
File name
INFO.FPG
15 - 43
15