Mitsubishi GOT2000 Series User Manual page 437

■1. Error display
When copying is not available between the GOT and the SD card, check the following contents according to the GOT
error display.
Error message
No SD card is installed.
The model information does not match.
The write protection switch of the SD card is ON.
No data to be a copy target exists in the copy source.
Touch
POINT POINT POINT
When installing or removing an SD card
Always set [Permissions] on the GOT. For details, refer to the following.
➠
15.4 SD Card Access
Step 6.
Copy is completed.
If the [ESC] button is touched, the
screen is closed.
If an error occurs during copy, an error
message appears.
For details of error messages, refer to
the following.
When only the project data was copied
to the GOT, touch the [ESC] button to
restart the GOT and display the user-
created screen.
When the basic system application was
copied, the GOT will automatically start
up and display the user-created screen.
(If the project data does not exist, a
message appears to notify that the
project data does not exist.)
Remedy
Install an SD card to the GOT.
The model set for the data in the SD card does not match with that of
the copy target GOT.
Use the same model data as that of the copy target GOT.
The write protection switch of the SD card is ON.
Turn off the write protection switch.
There is no data to be a copy target in the copy source.
Store the data to be copied in the copy source and copy it again.
➠
Error display
15 - 39
15.7 Data Copy
15