Jumper Settings; Jumper List - Winmate IH32 User Manual

3.5” sbc with intel 4th / 5th generation dual core i5 processors, hdmi, lvds, vga, dual giga ethernet, and mini-pcie interface

Hide thumbs Also See for IH32:

Table of Contents

IH32 Motherboard User Manual

2.4 Jumper Settings

This section explains how to set jumpers for correct configuration of the

motherboard.

NOTE:

A pair of needle nose pliers may be helpful when working with jumpers.

If you have any doubts about the best hardware configuration for your

application, contact your local distributor or sales representative before

you make any changes. Generally, you simply need a standard cable to

make most connections.

The jumper setting diagram is shown below. When the jumper cap is placed on both

pins, the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2

are short. If you remove the jumper cap, the jumper is OPEN.

The following table lists the function of each of the board's jumpers.

Label

JP1

JP2

JP3

JP4

SW0

Function

Backlight Power Selector

Panel Power Selector

PWM/DC Mode Control Selector 2x3 header, pitch 2.0mm

VR/Chipset Control Selector

Clear CMOS

Note

2x3 header, pitch 2.0mm

2x3 header, pitch 2.54mm

2x3 header, pitch 2.0mm

1x3 header, pitch 2.0mm

Table of Contents