CD Automation CD3200 User Manual page 43

CD Automation srl
P125L (H7D)
Function:
Value:
Default:
P125H (H7D)
Function:
Min/Max:
Value:
Default:
P126L (H7E)
Function:
Min/Max:
Value:
Default:
Note:
P126H (H7E)
Function:
Min/Max:
Value:
Default:
Note:
P127 (H7F)
Function:
Min/Max:
Value:
P128L (H80)
Function:
Min/Max:
Default:
Note:
P128H (H80)
Function:
Min/Max:
Default:
Note:
CD3200-1PH from 15A to 110A
Byte Lo = Feed-Back Type
This parameter set the Feed-Back Type
00 Hex = V2
20 Hex = V
40 Hex = I
80 Hex = VxI
20 (if not specified in the Order Code)
Byte Hi = Soft start time
The Unit starts in phase angle mode with a ramp starting from zero up to full
voltage in a presetted and Adjustable time.
The time is setted by this parameter
0 ÷ 255 (0 ÷FF Hex)
Each step is 50msec
20 (S+PA)
Byte Lo = HB Delay time
This parameter set a delay to have HB alarm active
1 ÷ 255 (0 ÷ FF Hex)
Each step is 50msec
30 (if not specified in the Order Code)
If Soft start option is enabled HB Delay time must be greater than Soft start
time: P126L x 50msec > P125H x 50msec
Byte Hi = HB sensibility
This parameter is the maximum reduction of Load Current to establish the HB
Alarm
0 ÷ 100 (0 ÷64 Hex)
Each step is 1% from Nominal Current
14 Hex
When you change this parameter, HB Calibration procedure is necessary.
Power Set
This parameter show the Power set saved by the Calibration Procedure
0 ÷ 65535 (0 ÷ FFFF Hex)
from 0 = 0% output power,
to 65535 = 100% output power.
Byte Lo = Integral
This parameter is the integral time of the feed-back loop
0 ÷ 255 (0 ÷FF Hex)
50 Hex
If you increase integral time you increase the output stability, but you increase
also the time to reach the set.
Byte Hi = Proportional
This parameter is the gain of the feed-back loop
0 ÷ 255 (0 ÷FF Hex)
VxI or V2 = 5 Hex
V or I =12 Hex
This parameter increase the loop speed but decrease the loop stability.
43
User's Manual
R/W
R/W
R/W
R/W
R/W
R/W
R/W