Sim2 NERO 3 PLUS Quick Start Manual page 11

that generate heat. Do not place the projector in an area where there is insufficient space
(shelving units, bookshelves and so on) and in general avoid placing it in poorly ventilated areas
as this may prevent sufficient cooling and significantly reduce lamp life.
Never look directly at the projection led
Never look directly into the lens when the led is on as the intense light may damage your eyes.
Take particular care that children cannot do so.
Take special care regarding movement of the lens
Do not place objects in the slots on the side of the lens and also ensure that vertical lens move-
ments are not impeded by external objects.
Do not insert objects through the openings in the projector
Make sure that no objects are inserted inside the projector. If this should occur, disconnect the
projector from the power supply immediately and call an authorized technician.
Power saving
We advise disconnecting the projector from the power supply when not in use. In this way you
will achieve considerable power savings while at the same time protecting internal electrical
parts from wear.
Class B emissions limits
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Environment
This product contains materials derived from natural resources during its manufacture. It may
contain materials that constitute a health and environmental hazard. To prevent harmful
materials from being released into the environment and to promote the use of natural
materials, SIM2 provides the following information regarding the disposal and recycling of the
product. Waste electrical and electronic materials (WEEE) should never be disposed of in normal
urban waste disposal facilities.
Observe the following instructions:
When you no longer wish to use your electrical and electronic equipment, take it to your
•
local waste disposal facility for recycling.
You may return your old equipment to your SIM2 Authorized Dealer free of charge when
•
you buy a new product that is equivalent or has the same functions as the old one. Contact
SIM2 to find your local dealer.
If you need more information regarding recycling, reuse and product exchanges, contact
•
SIM2 customer service.
Lastly we suggest further measures to safeguard the environment, such as recycling of internal
and external packaging (including that used for shipping) in which the product was delivered.
With your help, we can reduce the amount of environmental resources required to make
electric and electronic equipment, reduce the use of waste tips for used equipment and, in
general, improve our quality of life by making sure that hazardous materials are correctly
scrapped. Incorrect treatment of the product at the end of its service life and failure to follow
the above disposal instructions are punishable under local legislation.
DO NOT STARE INTO BEAM
CLASS 2 LED PRODUCT
P ≤ 0.88 mW λ = 452 nm
ICE 60825-1:1993 + A1:1997 + A2:2001
EN 60825-1:1994 + A2:2001 + A1:2002
The label on the product, shown here, indicating a canceled garbage can, is
intended to remind you that the product requires special handling at the end of its
service life. Materials such as glass, plastic and some chemical compounds are
recoverable and can be recycled for reuse.
LED LIGHT