Remote-Starting; Driving Off; Remote Starter Features; Idle Mode - Autostart Two-Way Led Transmission Remote Starter User Manual

Remote-starting

Press the
START/STOP
that the Remote Car Starter has received your signal. Approximately 5 seconds later, the engine
will start. The parking lights will remain
If the vehicle does not start at the first attempt, the system will shut down.

Driving Off

With the vehicle running under remote control, press the
doors. Enter the vehicle and do the following:
•
Turn the ignition key to the
position while the engine is running. This would cause the starter motor to re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.

Remote Starter Features

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
Idle Mode can be activated through the same routine as that used for Ready Mode; at the last step,
the button is pressed instead of the other buttons:
TRUNK
1. Ensure that all the Doors are closed and that the Shifter is in the Neutral position.
2. With the Engine already running, apply the Parking Brake and release the Brake Pedal.
Make sure to release the brake pedal.
3. Within 20 sec. push
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press the
door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Valet Modes

When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being
remote-started accidentally.
When the vehicle is set to valet mode, the LED remains ON (it does not flash). The LED will
turn itself off ONLY when the ignition key is turned to the

Ignition Valet

This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
To put the system i n t o Valet Mode:
• Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
User Guide
button for approx. 1 second. The parking lights will come
ON
IGNITION ON (RUN)
,
LOCK UNLOCK
button until the system is armed (the doors will be locked if remote
TRUNK
during the pre-programmed run time of the engine.
UNLOCK
position. (Do not turn the key to the
or on the Transmitter.
START/STOP
IGNITION ON
to inform you
ON
button to disarm and unlock the
position.
CRANK
P. 5