Home Valettm" Mode; Turbo Mode; Engine Run Time; Flashing Led - Autostart Two-Way Led Transmission Remote Starter User Manual

Turn the ignition key to the
•
Within 3 sec., press and release the valet button , the parking lights will flash twice
•
the L.E.D. will turn itself off.
Note: Once Valet Mode is activated, the remote starter will be disabled.

"Home ValetTM" Mode

If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote.
To take the system i n t o Home Valet Mode:
• Press the
button.
LOCK
• Within 3 seconds, press the
until the Parking Lights go out.
To take the system o u t o f Home Valet Mode:
• Turn the ignition key to the
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
• Go
then ; then
ON OFF
• Flash twice, pause; then
• Flash twice again.

Turbo Mode

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the Remote Car Starter to
Ready Mode.
To activate Turbo Mode, follow all steps of the Ready Mode routine :
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. press
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a.
LOCK
b.
UNLOCK
c.
START/STOP
(this will by-pass Turbo Mode).
D. TRUNK TO SET THE VEHICLE INTO IDLE MODE

Engine Run Time

If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3, 15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).

Flashing LED

The user may decide to turn on or off LED flashing at any moment. To do so, press and hold the
and buttons for 3 seconds:
LOCK UNLOCK
User Guide
START/STOP
IGNITION ON (RUN)
,
LOCK UNLOCK
to lock the doors and shut down the engine after 60 sec.;
to unlock the doors and shut down the engine after 60 sec.;
to shut down the engine immediately, without affecting the doors
position.
IGNITION ON (RUN)
and buttons simultaneously
LOCK
position.
or
START/STOP
on the transmitter.
P. 9