Download Print this page

Introduction; Basic Remote Operation; Remote-Starting Your Vehicle; Vehicle Presets - Autostart AS-1414 User Manual

Automatic transmission multi-channel remote starter system
Hide thumbs Also See for AS-1414:

Advertisement

INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device. To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication".
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.

Introduction

This module is a state-of-the-art remote car starter system. With many advanced function,
this product will satisfy any one of the user's expectations from high-end commodity systems,
without neglecting the standard features commonly offered by entry-level starters.

Basic Remote Operation

The system is equipped with a 4-button multi-channel transmitter.
The functions of the transmitter are as follows:

Remote-starting Your Vehicle

Press the
button for approx. 1 second. The parking lights will come
, informing
START/STOP
ON
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
parking lights will remain
during the pre-programmed run time.
ON
If the vehicle doesn't start the first time, the system will shut down, wait a few seconds, and
try to start the engine again. It will try to start the engine 3 times before giving up.

Vehicle Presets

Heater and Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation
for the next remote start. Settings for the blower motor (fan), front and rear, as well as
heated seats (if equipped) should not be left on
. It is recommended to leave the settings
HIGH
on
or
instead.
LOW
MEDIUM
P. 2
User Guide AS-1414/ AS-1424

Hide quick links:

Advertisement

loading

This manual is also suitable for:

As-1424