Table of Contents
Advertisement
T W O - W A Y L E D M A N U A L T R A N S M I S S I O N
FCC USER NOTICE (U.S.A.):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
authority to operate the equipment.
DOC: 1.00 (i) –
R E M O T E
User Guide
It is the responsibility of the vehicle operator to ensure
their vehicle is parked in a safe and responsible
manner.
1. When leaving the vehicle, it is the user's responsibility to
ensure that the gearshift lever is in the NEUTRAL position
and the parking brake is engaged in order to avoid accidents
upon remote starting.
2. It is the user's responsibility to ensure that the remote
starter is disabled or put into valet mode before servicing.
August 29, 2006
S T A R T E R
WARNING
DL Lp
Manufactured in Canada by Autostart
Advertisement
Table of Contents
Related Manuals for Autostart Two-Way Led Transmission Remote Starter
Summary of Contents for Autostart Two-Way Led Transmission Remote Starter
- Page 1 Such modifications could void the user's authority to operate the equipment. August 29, 2006 DOC: 1.00 (i) – R E M O T E S T A R T E R WARNING DL Lp Manufactured in Canada by Autostart...
-
Page 2: Table Of Contents
Remote-Starting Your Vehicle ... 4 Setting Your Vehicle into Ready Mode ... 4 Remaining In Ready Mode... 4 Remote-starting ... 5 Driving Off... 5 Remote Starter Features ... 5 Idle Mode... 5 Valet Modes... 5 Ignition Valet ... 5 Remote Valet Mode ... 6 Panic Mode... -
Page 3: Using The Remote Control
Using the Remote Control Your remote starter is equipped with a 5-button multi-channel remote control. It can operate two independent vehicles equipped with a remote starter (see Multi-car operation section on page 10). The functions of the transmitter are as follows: For certain vehicles: •... -
Page 4: Arming The Starter Kill
Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes (parking lights). P. 4 even after remote starter shut down, resulting in a dead button on the transmitter. UNLOCK button on the transmitter. -
Page 5: Remote-Starting
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni- ence store, lock your vehicle and leave it running for the length of a run cycle while you are away. -
Page 6: Remote Valet Mode
• The parking lights will flash twice to indicate that the vehicle is now in Valet Mode. The L.E.D. will go out. Note: With the Remote Valet activated, the remote starter will be disabled. Remote Valet Mode This feature will allow you to remotely put your system into Valet Mode by using the transmitter instead of the Valet button as above. -
Page 7: Extended Run Time
• Press the brake pedal. • Press the button then press and hold the SHIFT (the parking lights will flash once). When the vehicle exits Cold Weather Mode, the Parking Lights will flash once. If Safe Start is enabled, you can activate Cold Weather Mode by •... -
Page 8: Priority Door Access
Priority Door Access If the Remote Door Locks option is installed on your vehicle, this safety feature allows you unlock solely the driver’s door with a single press of the press of the button, all the other doors will unlock. UNLOCK Ignition-controlled Door Locks This is an added security feature. -
Page 9: Home Valettm" Mode
Within 3 sec., press and release the valet button , the parking lights will flash twice • the L.E.D. will turn itself off. Note: Once Valet Mode is activated, the remote starter will be disabled. “Home ValetTM” Mode If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if the vehicle is parked indoors there is no danger of it starting accidentally by remote control. -
Page 10: Multi-Car Operation
• Flashing LED : the L.E.D. will flash at all times (either under active arming or under passive arming) to indicate that the starter kill is active. • Active Arming: the LED will flash normally. • Passive Arming: the LED will not flash during the countdown preceding the activation of the Starter Kill. -
Page 11: Vehicle Status Request
Your installer can customize the system as to personalize these multi-level features in an order that best suits you. Your options are: Level 1 (requires pressing the Level 2 (requires pressing the Level 3 (requires pressing the Level 1 (requires pressing the Level 2 (requires pressing the Level 3... -
Page 12: Status Request When The Engine Is Not Running
Status Request When the Engine IS NOT Running STATUS SEQUENCE Lock Unlock sequence if locked Cold sequence if Weather unlocked sequence sequence if locked Home sequence if Valet unlocked sequence sequence if locked Valet sequence if Mode unlocked sequence Ready Mode Status Request STATUS SEQUENCE if locked... -
Page 13: Status Request When The Engine Is Running
Status Request When the Engine is Running When the vehicle doors are locked: The LED # 1 will flash 3 times to denote that the vehicle’s doors are locked. When the vehicle doors are unlocked: The LED # 2 will flash 3 times to denote that the vehicle’s doors are unlocked. RUN TIME If there is more than 3/4 of run time cycle... -
Page 14: Diagnostics - Parking Light Flash Table14
Diagnostics – Parking Light Flash Table Flashes • Doors locked, starter kill armed. • Run time has expired. • TRUNK button pressed. • Start signal received by the module. • Cold weather mode cancelled. • Remote start attempt cancelled by remote. •...
Need help?
Do you have a question about the Two-Way Led Transmission Remote Starter and is the answer not in the manual?
Questions and answers