Main Menu; Averaging; Mean Value Configuration - TESTO 454 Instruction Manual

Main menu

Multi-pt
Mv config
Memory
Enter / Ein
On
Time s
No 0 %
Act 27.7˛
Mv
•
Time 5 s
No 2 %
Act 27.7
Mv 26.9˛
Channel Channel
1: % 2: °C
Duration Duration
10 s 10 s
Ein Ein
Enter / Enter /
On On
Channel
K1: %
Duration
˛10 s
1
2
5
Channel
K1: %
Duration
125 s
Ein
Enter /
On
Main menu
Multi-pt
µv config
Memory
8
The parameters, taken as a basis when averaging,
are defined by you in the menu point "M
A measuring rate of 1 second is the basis for averag-
ing. The time is defined in the menu "M
Select "M " from the main menu.
-
ULTI PT
Measurement is started via the <Point> key.
The mask gives information on the
- remaining averaging time in seconds,
- number of averagings,
- parameter to be averaged (unit),
- current measured value,
- averaged measured value.
An averaging calculation which has been started can
be cancelled with the <Arrow> key and the measured
values are not saved. When leaving the menu by
pressing <Enter> the individual mean values and the
total mean values are automatically saved as a
protocol with the current location. Saved mean val-
ues can be called up in the menu "V

8.2 Mean value configuration

Open the "M " menu.
C
V ONFIG
Select a channel (=Parameter) via <up>/<down>.
Confirm with <Enter>, the cursor jumps to the next
line.
Enter the duration of the averaging in seconds (three
digit value e.g. 030 ). Confirm with <Enter> and you
return to the main menu.
If you wish to check the entry or take an average
directly move the cursor via <up> to "M
confirm with <Enter>.
Proceed in the "M - " menu as described above.
ULTI PT
Main menu

8.1 Averaging

C ".
V ONFIG
C ".
V ONFIG
".
IEW MEMORY
" and
-
ULTI PT
15