Measuring - TESTO 454 Instruction Manual

testo
Ein
Enter /
On
˛˛˛˛˛˛˛˛˛˛
˛˛˛˛˛˛˛˛˛˛
˛˛˛˛˛˛˛˛˛˛
˛˛˛˛˛˛˛˛˛3
P.inactive
1: 26.4 %
1: 25.8 °C
1: 6.5td°
P.inactive
1: 6.5td°
2: 48.8 %
2: 23.8 °C
Ein
Enter /
On
Main menu
Multi-pt
Mv config
Memory
Main menu
Print
Location
Device
Main menu
Device
Probes
Specials
14
7
Operating instructions
When measuring the probes must be connected
before the instrument is switched on.
Insert one or more probe plugs into the data logger
socket(s). It does not matter which socket you
choose as the data logger recognises the assign-
ment of the input channels and the probes conn-
ected.
Switch on the instrument.
A short function test is carried out.
The instrument then goes to the measuring menu.
A 4 line display appears.
The first line shows the program status, in this case
"P. inactive" for program inactive which means that a
measurement is not activated (activated programs
wait on the respective programmed starting criterion,
see Chapter 8.3.3).
The current measured values are shown in the fol-
lowing lines. The input channel (socket no.) is shown
in the left column while the current measured value is
shown in the right column.
Using <up>/<down> the measured values can be
scrolled up and down in the display (if more than 3
are active).
Leave the measuring menu by pressing <Enter> and
change to the main menu.
The main menu includes the following submenus:
Averaging
Mean value configuration
Memory
Print
Location
Device
Probes
Specials

7.1 Measuring

Chapter 8.1
Chapter 8.2
Chapter 8.3
Chapter 8.4
Chapter 8.5
Chapter 8.6
Chapter 8.7
Chapter 8.8