Activating Duration And Program - TESTO 454 Instruction Manual

Program
∂uration
0 sec
activ.off
Program
# of val.
activ.off
Program
øpen End
activ.off
Enter / Ein
On
Program
Open End
Å
activ.off
Program
Open End
active.øn
Ein
Enter /
On
Memory
View
State
πrog.I
•
A.P:1e
1: 24.4 %
1: 22.5 °C
1: 1.3td°
8

8.3.3.3 Activating duration and program

By confirming the input "P
ROGRAM RATE
you will go to the input mask "P
ROGRAM DURATION
You have 3 ways of defining the program duration:
1) as a time range (="Duration")
2) as a "# of values"
3) as an "Open End" measurement i.e. the measure-
ment runs until the memory is full or crashes.
If the trigger function refers to measured values, the
number of saved values can be lower than the number
of values programmed to be measured. Cause: the pro-
gram running was prematurely interrupted because of
the following:
- a second activated program has been
started or
- the starting criterion for the current
program has not been fulfilled.
Confirm your entries with <Enter>.
To activate the program, switch the display
"activ.off" to "activ.on" via <up> <down>.
The program can be activated at any time.
When confirmed with <Enter> the measuring instru-
ment takes over programming and goes back to the
"M " submenu.
EMORY
Main menu
8.3 Memory
"with <Enter>
".
21