Printing The Measured Values On The Infrared Printer; Saving Measured Values - TESTO 454 Instruction Manual

6.2 Printing the measured values on the infrared printer

6
Print
Values
Protocol
Settings
Ein
Enter /
On
Drucken
µesswerte
Protokoll
Einstell.
Aus
Off
Enter / Ein
On
7 8 9
4 5 6
1 2 3
0 •
P.inactive
1: 47.8 %
1: 23.4 °C
2: 47.8 %
•
Act.Values
stored
Location:
LENZKIRCH
Ein
Enter /
On
P.inactive
1: 47.8 %
1: 23.4 °C
2: 47.8 %
6
Introductory training
From the measuring menu go to the submenu "Print"
by pressing the key <6>, selection is on "M
".
VALUES
Switch on the printer.
Position the printer and the measuring instrument
such that the red control lamp is pointing in the direc-
tion of the infrared diode in the testo 454 measur-
ing instrument.
Confirm the menu point selected "P
" with <Enter>.
VALUES
The printer immediately prints the current measured
values.
Ensure that the infrared connection from the
measuring instrument to the printer is not inter-
rupted during the printing otherwise you may have
an incomplete printout.
Go back to the measuring menu after printing by
pressing <Arrow> twice.

6.3 Saving measured values

Save the current measured values out of the measu-
ring menu via the <point> key.
"Act.Values stored Location: LENZKIRCH" appears
in the display. The location "LENZKIRCH" is set in
the factory. It is possible to change the measuring
location or to set up a selection of different locations
(see next page).
Return to the measuring menu by pressing <Enter>.
EASURED
- M
RINT EASURED
11