Table of Contents
Advertisement
Checking the Conveyor Belt Chains
NOTE: The Bun Thickness Compression Knobs
(Figure 7) must be set to "6 & 6" prior to measur-
ing or removing or reinstalling the Conveyor Belt
Chains.
MEASURING CONVEYOR BELT CHAINS
1. Turn the unit off, unplug the power cord, and
allow the unit to cool.
2. Remove the Bun Feeder, Butter Wheel, Pan, and
Heat Shield (Figure 1) and set the Bun Thickness
Compression Knobs to 6 & 6.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the zipper (Figure 9).
4. Remove the Belt Wrap.
5. Facing the toaster, locate the approximate center-
point of the Conveyor Chain.
6. Pull the Conveyor Chain away from the edge of
the toaster (Figure 12).
7. Stand a U.S. Dime on end between the frame
and the chain (Figure 12).
8. If the gap is significantly wider than the coin,
REMOVE links as described below.
9. Disconnect the Conveyor Belt Chain by squeez-
ing any two links together and unhooking both
ends one link (Figure 13). Needle-nose pliers
may be used.
NOTE: There are two small 1/2" links on each side
of the Conveyor Belt Chain. The rest are large 3/4"
links.
10. Remove one 1/2" link from the belt.
11. Reassemble the Conveyor Belt Chain onto the
sprockets as described in Replacing Conveyor
Belt Chains.
12. Measure the gap again to ensure it is not too
tight.
13. Check the opposite side of the toaster using the
same steps.
NOTE: If the Conveyor Belt Chain is too tight to be
reassembled, remove an additional small 1/2" link
and install a large 3/4" link in its place. This will
shorten the Conveyor Belt Chain by 1/4" overall.
P/N 1010807 Rev. I 06/12
MAINTENANCE (continued)
Large Link
P/N 0800121
Small Link
P/N 0800204
REPLACING CONVEYOR BELT CHAINS
5. Disconnect the Conveyor Belt Chain by squeezing
NOTE: The ends of the hooks must point down
(Figure 13).
NOTE: Make sure the Conveyor Belt Chain is
installed under the Upper Support Rod and over the
Lower Support Rod.
13
VERTICAL CONTACT TOASTER
Figure 12. Removing Conveyor Belt Chain
Upper Support Rod
Figure 13. Removing Conveyor Belt Chain
1. Turn the power off, unplug the power cord, and
allow the unit to cool before proceeding.
2. Remove the Butter Wheel, Pan, and Heat Shield
and set the Compression Control Knobs to 6 & 6.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the zipper.
4. Remove and discard the old Belt Wrap(s).
any two links together and unhooking both ends
of one link (Figure 13).
5. Place the replacement Conveyor Belt Chain on
the top sprockets with hook ends down.
6. Wrap the Conveyor Belt Chain around the top
and lower sprockets and connect by hooking both
ends together.
Rotation
A.J. Antunes & Co.
Advertisement
Table of Contents
