Voltage And Fuse Requirements; Removing And Replacing Fuses - Waters 2410 Operator's Manual

4. Make sure that the new fuse is properly rated for your requirements (see Table 6-1).
5. Insert the new fuse into the fuse holder.
6. Insert the fuse holder into the rear panel receptacle and gently push until it locks into
6
position.
Table 6-1 identifies the 2410 refractometer fuse requirements.
Table 6-1 Voltage and Fuse Requirements
Nominal Voltage
100 Vac to 240 Vac
6-4 Maintenance Procedures
Fuse
Receptacle
Fuse
Holder
Figure 6-1 Removing and Replacing Fuses
Frequency
50/60 Hz
Power Input
Required Fuse
F 2.0 A