Installing And Removing The Interface Module; Installing The Interface Module - Cisco ASR-920-24SZ-IM Hardware Installation Manual

Installing and Removing the Interface Module

Installing and Removing the Interface Module

The sections describe the installation and removal of interface module on the Cisco ASR-920-24SZ-IM Router.

Installing the Interface Module

Before installing the interface module, read the Activating or Deactivating Interface Module section in
Note
the Cisco ASR 920 Series Aggregation Services Router Configuration
SUMMARY STEPS
1. Before inserting an interface module, make sure that the chassis is grounded.
2. If present, remove the blank filler plate covering the interface module slot. To remove, pull the blank filler
plate completely out of the router slot using the captive screws.
3. To insert the interface module, carefully align the edges of the interface module between the upper and
lower edges of the interface module slot in the router.
4. Carefully slide the interface module into the router slot until the interface module makes contact with the
backplane. The following figure shows how to install the interface module on Cisco ASR-920-24SZ-IM
Router.
5. Tighten the locking thumbscrews on both sides of the interface module. The recommended maximum
torque is 5.5 in.-lb (.62 N-m).
6. Connect all the cables to each interface module.
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
66
Installing the Router
Guide.