Configuring Global Parameters - Cisco ASR-920-24SZ-IM Hardware Installation Manual

Configuring Global Parameters

Configuring Global Parameters
When you first start the setup program, configure the global parameters. These parameters are used for
controlling system-wide settings. Perform the following steps to enter the global parameters:
SUMMARY STEPS
1. Connect a console terminal to the console port, and then boot the router. For more information on connecting
a console terminal, see Connecting Console Cables section.
2. The first sections of the configuration script appear only at an initial system startup. On subsequent uses
of the setup facility, the script begins with a System Configuration Dialog as shown below: When you are
prompted about whether you want to enter the initial configuration dialog, enter yes.
DETAILED STEPS
Step 1
Connect a console terminal to the console port, and then boot the router. For more information on connecting a console
terminal, see Connecting Console Cables section.
The following is only an example of the output display; prompts may vary.
Note
When you see this information, it means that you have successfully booted your router:
Example:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2
The first sections of the configuration script appear only at an initial system startup. On subsequent uses of the setup
facility, the script begins with a System Configuration Dialog as shown below: When you are prompted about whether
you want to enter the initial configuration dialog, enter yes.
Example:
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended
setup will ask you to configure each interface on the system.
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
124
Initial Configuration