Installing And Removing A Spa Interface Processor; Online Insertion And Removal; Preparing For Online Removal Of A Sip - Cisco uBR10012 Hardware Installation Manual

Universal broadband router sip and spa

Hide thumbs Also See for uBR10012:

Table of Contents

Installing and Removing a SPA Interface

Processor

•

The Cisco uBR10012 router supports online insertion and removal (OIR) of the SPA interface processor (SIP)

and of the shared port adapters (SPAs). Therefore, you can remove a SIP with its SPAs still intact, or you can

remove a SPA independently from the SIP, leaving the SIP installed in the router.

Important

Note

If the SIP is running normally in chassis, SPA cards can be installed and removed directly from SIP without

installing SIP.

See "Preparing for Online Removal of a SIP" section in the

SIP and SPA Software Configuration

For more information about the recommended procedures for physical removal of the SIP, see

Removing a SPA Interface Processor

Online Insertion and Removal, page 65

Handling SIPs, page 66

SIP Installation and Removal, page 67

If you are replacing the SPA after a duration of three months, perform a field upgrade of the SPA. Do not

perform an OIR. For more information on field upgrade, see

Cisco uBR10012 Universal Broadband Router SIP and SPA Hardware Installation Guide

C H A P T E R

Cisco uBR10012 Universal Broadband Router

Guide.

chapter.

Field Upgrade of the SPA, on page

79.

Installing and

Table of Contents