Connecting A Cable To The Output 10-Mhz Or 1-Pps Interface; Connecting A Cable To The Tod Interface; Cisco Asr-920-24Sz-Im, Asr-920-24Sz-M, Asr-920-24Tz-M Aggregation Services Router Hardware Installation - Cisco ASR-920-24SZ-IM Hardware Installation Manual

Installing the Router
DETAILED STEPS
Step 1 Connect one end of a shielded mini-coax cable to the GPS unit.
Step 2 Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the RSP of the Cisco
ASR-920-24SZ-IM Router.

Connecting a Cable to the Output 10-Mhz or 1-PPS Interface

SUMMARY STEPS
1. Connect one end of a shielded mini-coax cable to the Slave unit.
2. Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the RSP of the
Cisco ASR-920-24SZ-IM Router.
DETAILED STEPS
Step 1 Connect one end of a shielded mini-coax cable to the Slave unit.
Step 2 Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the RSP of the Cisco
ASR-920-24SZ-IM Router.

Connecting a Cable to the ToD Interface

SUMMARY STEPS
1. Connect one end of a straight-through Ethernet cable to the GPS unit.
2. Connect the other end of the straight-through Ethernet cable to the ToD or 1-PPS port on the RSP of the
Cisco ASR-920-24SZ-IM Router.
DETAILED STEPS
Step 1 Connect one end of a straight-through Ethernet cable to the GPS unit.
Step 2 Connect the other end of the straight-through Ethernet cable to the ToD or 1-PPS port on the RSP of the Cisco
ASR-920-24SZ-IM Router.
For instructions on how to configure clocking, see the Cisco ASR 920 Series Aggregation Services Routers
Note
Configuration Guide.

Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation

Connecting Timing Cables
Guide
113