Installing The Router In A Rack; Installing The Chassis Brackets - Cisco ASR-920-24SZ-IM Hardware Installation Manual

Installing the Router in a Rack

Installing the Router in a Rack

The procedures in this section apply to both horizontal and vertical mounting of the router in a rack.

Installing the Chassis Brackets

The chassis is shipped with mounting brackets that can be installed on the front or rear of the chassis. To
install the brackets on the front of the chassis, perform these steps:
SUMMARY STEPS
1. Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
2. Position one of the brackets against the chassis side, and align the screw holes.
3. Secure the bracket to the chassis with the screws removed when performing Step 1. The recommended
maximum torque is 10 in.-lb.
4. Repeat Step 3 and Step 3 for the other bracket.
DETAILED STEPS
Step 1 Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
Step 2 Position one of the brackets against the chassis side, and align the screw holes.
19-inch EIA Rack
The following figures show how to attach the brackets at the front, middle, and rear positions on the Cisco
ASR-920-24SZ-IM Router for a 19-inch EIA rack.
Figure 14: Attaching Mounting Brackets to Cisco ASR-920-24SZ-IM Router for a 19-inch EIA Rack (Front, Middle, and Rear Positions)
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
50
Installing the Router