Accessing The Cli Using The Console; Configuring Global Parameters - Cisco ASR 902U Hardware Installation Manual

Cisco Router Initial Configuration
To configure a Cisco Router from the console, you must connect a terminal or terminal server to the console
port on the Cisco Router RSP. To configure the Cisco Router using the management Ethernet port, you must
have the router's IP address available.

Accessing the CLI Using the Console

To access the command line interface using the console, follow these steps:
Step 1
When your system is booting, type No at the prompt.
Example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to enter user EXEC mode. The following prompt appears:
Router>
Step 3 From the user EXEC mode, enter the enable command as shown in the following example:
Router> enable
Step 4 At the password prompt, enter your system password, as shown in the following example. If an enable password has not
been set on your system, this step may be skipped.
Password: enablepass
When your enable password is accepted, the privileged EXEC mode prompt is displayed:
Router#
You now have access to the CLI in privileged EXEC mode and you can enter the necessary commands to complete your
desired tasks.
Step 5
To exit the console session, enter the quit command as shown in the following example:
Example:
Router# quit

Configuring Global Parameters

When you first start the setup program, you must configure the global parameters. These parameters are used
for controlling system-wide settings. Perform the following steps to enter the global parameters:
Step 1 Connect a console terminal to the console port, and then boot the router. For more information on connecting a console
terminal, see Connecting Console
This is only an example of the output display; prompts may vary.
Note
Cablessection.
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
Accessing the CLI Using the Console
117