Table of Contents
Advertisement
Connect Router to the Network
Connecting a Cable to the GNSS Antenna Interface
The GNSS LED is located on the front side of the chassis.
Step 1
Connect one end of a shielded coaxial cable to the GNSS RF IN port.
Step 2
Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.
Note
The GNSS RF In port should have a primary protector installed to meet the Local Safety guidelines.
Figure 67: NCS 57B1 GNSS Port
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
Connecting a Cable to the GNSS Antenna Interface
83
Hide quick links:
Advertisement
Table of Contents
