Hardware Installation Manual
To cable the PEM modules for BITS synchronization mode:
1.
Connect the Trunk from BITS source A to the RJ-48 port (labeled BITS/SETS), located
on the lower PEM module (A).
2.
Connect the Trunk from BITS source B to the RJ-48 port (labeled BITS/SETS), located
on the upper PEM module (B).
Legend
1
2
3
4
Version 7.0
Figure 5-14: Connecting BITS Trunk Sources on PEM
Connects trunk from BITS Source A
Connects trunk from BITS Source B
Lower PEM #1 (A)
Upper PEM #2 (B)
Description
65
5. Cabling the Device
Mediant 3000