Replacing The Power Supply Module - AudioCodes Mediant 3000 Hardware Installation Manual

Media gateway & enterprise session border controller

Hide thumbs Also See for Mediant 3000:

Table of Contents

6.3

Replacing the Power Supply Module

The procedure below describes how to replace the Power Supply module.



To replace a faulty Power Supply module:

Remove the faulty Power Supply module:

Using a Philips screwdriver, unfasten the two screws located on the module.

Press the red ejector buttons on the module's black ejector/injector latches.

Pull on the ejector/injector latches and then gently ease the module out of the slot.

Insert the replacement Power Supply module:

With the black ejector/injector latches in the open (pulled out) position, align the

module's edges with the groves inside the slot.

Gently ease the module (using your thumbs to push the module) into the slot until

the module is flush with the chassis.

Press the module's black ejector/injector latches inward, toward the middle until

you hear a click.

Secure the module to the chassis by fastening the two screws (using a Philips

screwdriver) located on the module.

Hardware Installation Manual

Mediant 3000

Document #: LTRT-94720

Table of Contents