Table 3-14: Sa/M3K Blade Leds Description - AudioCodes Mediant 3000 Hardware Installation Manual

Hardware Installation Manual
Label
FAIL
ACT
BITS/SETS
STATUS (1
& 2)
BITS/SETS
ACT SRC
(1 & 2)
PWR
SWAP
READY
Version 7.0

Table 3-14: SA/M3K Blade LEDs Description

Color Status
Red On Blade failure (fatal error).
- Off Normal operation.
Green On Active blade initialization sequence completed
successfully.
Note: This is applicable only to HA mode.
Yellow On Standby blade initialization sequence terminated
successfully.
Note: This is applicable only to HA mode.
Blinking Blade initialization sequence terminated successfully.
- Off Standalone blade.
Green On Framer locked on BITS clock.
Note: Each LED (1 or 2) depicts the BITS source
connected either to the upper or lower PEM module on
the device's rear panel. Therefore, only one of the LEDs
is applicable (they change only if the BITS source is
changed).
Red On Timing source failure or BITs is not in use.
- Off This BITS clock reference is not used.
Green On Active clock source.
Note: Each LED (1 or 2) depicts the BITS source
connected either to the upper or lower PEM module on
the device's rear panel. Therefore, only one of the LEDs
is applicable (they change only if the BITS source is
changed).
Red On Timing source failure.
- Off This is not an active source.
Green On Blade receiving power.
Off No power received by blade.
-
On Blade can be fully inserted or removed (after being
Blue
partially inserted or removed).
Off Blade is successfully inserted (not ready to be removed).
-
Description
35
3. Physical Description
Mediant 3000