Table 2-17: Sa/M3K Blade Leds Description - AudioCodes Mediant 3000 Installation Manual

Installation Manual
Label Color
FAIL Red
-
ACT Green
Yellow
-
BITS/SETS Green
STATUS (1
& 2)
Red
-
BITS/SETS Green
ACT SRC
(1 & 2)
Red
-
PWR Green
-
SWAP Blue
READY
-
Version 5.8

Table 2-17: SA/M3K Blade LEDs Description

Status
On Blade failure (fatal error).
Off Normal operation.
On Active blade (applicable only to Mediant 3000 HA configuration)
initialization sequence completed successfully.
On Standby blade (applicable only to Mediant 3000 HA configuration)
initialization sequence terminated successfully.
Blinking Blade initialization sequence terminated successfully.
Off Standalone blade.
On Framer locked on BITS clock.
Note: Each LED (1 or 2) depicts the BITS source connected
either to the upper or lower PEM module on the device's rear
panel. Therefore, only one of the LEDs is applicable (they change
only if the BITS source is changed).
On Timing source failure.
Off This BITS clock reference is not used.
On Active clock source.
Note: Each LED (1 or 2) depicts the BITS source connected
either to the upper or lower PEM module on the device's rear
panel. Therefore, only one of the LEDs is applicable (they change
only if the BITS source is changed).
On Timing source failure.
Off This is not an active source.
On Blade receiving power.
Off No power received by blade.
On Blade can been fully inserted or extracted (after being partially
inserted or extracted).
Off Blade has been successfully inserted (not ready to be extracted).
Description
35
2. Physical Description
July 2009