Removing An Expansion Card From The Expansion Card Riser 3 - Dell PowerEdge R830 Owner's Manual

Removing an expansion card from the expansion card riser 3

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Holding the touch points on the riser, lift the expansion card riser out of the chassis.
Steps
1. Disconnect any cables connected to the expansion card.
2. Open the expansion card retention latch.
NOTE: If you are removing a full-height expansion card, open the expansion card holder.
3. Hold the expansion card by its edges, and remove it from the expansion card connector.
4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the
expansion card latch.
NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
5. Close the expansion card riser latch into the slot.
Figure 57. Removing a half-height expansion card from the expansion card riser 3
1. expansion card 2. expansion card retention latch
115