Dell PowerEdge R830 Owner's Manual page 114

Steps
1. If applicable, unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying
the card.
2. Open the expansion card latch and remove the filler bracket.
3. Holding the card by its edges, insert the card edge connector firmly into the expansion card connector until the card is fully
seated.
Figure 56. Installing an expansion card into the expansion card riser 2
1. expansion card riser 2
3. touch point (2)
5. expansion card
4. Close the expansion card latch into the slot.
Next steps
1. Install the expansion card riser 2.
2. Follow the procedure listed in the After working inside your system section.
3. Install any device drivers needed for the card as described in the documentation for the card.
Related links
Safety instructions
Before working inside your system
Removing an expansion card from expansion card riser 2
After working inside your system
114
2. expansion card connector
4. expansion card latch