Dell PowerEdge R830 Owner's Manual page 145
Hide thumbs
Also See for PowerEdge R830:
- Getting started (8 pages) ,
- Quick start manual (8 pages) ,
- Getting started with your system (8 pages)
Table of Contents
Advertisement
Steps
1.
Using a Phillips #2 screwdriver, remove the screw(s) securing the control panel to the chassis.
CAUTION: Do not use excessive force when removing the control panel as it can damage the connectors.
2.
Remove all the cables connecting the control panel to the system board.
NOTE: Ensure that you remove the cooling fan assembly before you remove the USB power cable.
3.
From inside the system, push the control panel out of the chassis.
Figure 87. Removing the control panel
1.
control panel
3.
control panel connector cable
4.
You can remove the vFlash connector/USB connector module from the control panel using the following steps:
a. Disconnect the control panel cable from the control panel.
b. Remove the screws that attach the vFlash connector/USB connector module to the control panel.
c. Pull the vFlash connector/USB connector module to disengage from the control panel module.
2.
screw (2)
4.
USB connector cable
145
Advertisement
Table of Contents
Troubleshooting
