Dell PowerEdge R830 Owner's Manual page 117

Steps
1. If applicable, unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Open the expansion card retention latch.
3. Holding the card by its edges, insert the card-edge connector firmly into the expansion card connector until the card is fully
seated.
4. If you are installing a full-height expansion card, pull the expansion card holder toward the expansion card riser. Ensure that the
expansion card rests between the grooves on the expansion card holder.
5. Close the expansion card riser latch into the slot.
Figure 59. Installing a half-height expansion card into the expansion card riser 3
1. expansion card
3. expansion card connector
2. expansion card retention latch
4. expansion card riser
117