Dell PowerEdge R830 Owner's Manual page 103

Steps
1. Holding the slots on the expansion card riser, lift the riser from the riser connector on the system board.
2. To remove expansion card riser 3, hold the edges of the expansion card riser.
NOTE: To ensure proper system cooling, the riser blank must be installed in the appropriate riser slot. Remove the
riser blank only if you are installing a riser.
Figure 44. Removing the expansion card riser 1
1. expansion card riser 1
3. riser guide (right)
5. riser guide (left)
2. touch point (2)
4. expansion card riser 1 connector
103