OREC LS 280 Owner's Manual page 16

CAUTION
Do not use inflammable oil such as gasoline and thinner.
Other Inspection
1. Check if each handling lever works properly. (Each time before starting the engine.)
2. Stretch the V belt after a few driving hours, as it tends to be loose at first.
(Refer to "Driving Clutch Wire".)
3. Move the machine a little to check unusual sound and heat.
4. Avoid working too hard for a first few hours to adjust each part of the machine.
5. Do not forget to service after working and check the machine regularly.
(Refer to "List for Regular Self-Inspection".)
6. Check if the bolts and nuts are not loosened or fallen.
7. Check the entire machine to see if the oil is not leaking.
If the oil is leaking, consult the dealer where you purchased the machine.
Do not keep using the machine with the leaking oil, or it may cause an accident and damage the machine.
MONTHLY MAINTENANCE
Inspecting Fuel Pipe
The rubbers such as the fuel pipe deteriorate even if unused. Exchange
them together with the fastening band every 3 years or when damaged.
Keep checking if the pipes and the fastening band are loosened or
damaged.
Tips; when exchanging the pipes are careful not to let dust go into the
pipes.
Draining transmission oil
Fuel hose Figure 15
- Prepare a proper vessel for receiving the oil.
- Detach the drain plug (A, figure 16) at the underside of the
transmission case and drain the oil.
Tips: Detach the oiling cork as well, and the oil can be drained easily.
- Attach the drain plug tightly and supply 1.60L of the transmission oil
(SAE 90 or API GL-5).
When to Exchange:
For the First Time: after 50 Hours
Later: every 100 Hours
Figure 16
Do not throw used oil.
Draining Engine oil
- Prepare a proper vessel for receiving the oil.
- Detach the drain plug (A, figure 17) at the bottom of Engine
Tips: Detach the oiling cork as well, and the oil can be drained
easily.
- Attach the drain plug tightly.
When to Exchange:
Figure 17
For the First Time: after 50 Hours
Later: every 100 Hours
© SAT – 09/2006 16