OREC LS 280 Owner's Manual page 5

Never stop or start roughly when working on a slope. Never use the machine to work on a stepping
•
Stay clear of unsteady embankments, holes or rocks. They might be dangerous during work or
•
transport.
Keep away from electric wires and obstacles. A contact with electric wires cause electrocution and
•
death.
Stop the machine progressively when lifting or lowering the machine.
•
When stopping the work, stop the engine and remove the sparking plug ignition cover before leaving
•
the mower.
Engage all the safety equipments.
•
Move the controls only when correctly sat down in the mower
Visually check hydraulic leaks and if some parts are faulty or missing. Repair before use.
•
Never change the adjustment of the regulator, it is set in the factory. Unsetting the regulator would cause
failures.
Ensure that the user of the machine has already read and understood this
•
manual and that he is aware of all the safety instructions before any use.
Always use a chuck and bronze hammer when replacing or intervening
•
on the pins and bolts at the end of rams, rod ... etc in order to avoid the
projection of metal fragments.
© SAT – 09/2006
terrain.
Reduce the ground speed when driving on a slope and when turning straight
•
in order to prevent from any risk of losing control.
Be very careful when bordering ditches.
•
Stop the engine, and remove the sparking plug ignition cover before any
•
intervention on the machine.
Never work under the machine or its parts when lifted, unless they are
•
blocked and maintained into position with sufficient security.
When driving on a slope, always work going up or down but never across the
•
slope.
5