OREC LS 280 Owner's Manual page 14

If the loading box is unlocked on the slope or when the load is clustered on the front side the
loading box may suddenly start dumping.
How to stop the machine
Release the travel clutch lever. (Figure 10)
•
Pull back the throttle lever to idle position.
•
Stop the engine.
•
Turn the Fuel cock off position
•
WARNING
Never park the machine on
slopes. Stop it on a level and
flat surface.
Storing the machine
Thoroughly clean the machine. Use touch up paint to prevent rust. Check for worn and damage parts,
install new parts as required. Perform the normal maintenance of the machine according to maintenance
chart. Store the machine in a dry protected area. Remove sparking ignition wire from the sparking plug.
Loading/unloading
Do not ride on the foot rest when loading or unloading the lorry with the
machine or on the slope. Ride only on the level ground.
Drive the machine on foot with a low speed when loading or
unloading the lorry with the machine or on the slope.
After unlocking the handlebars, move the handlebars securely to the position for "riding on foot
rest" or "walking" and lock the handlebars with the handle lock pedal. (LS280)
© SAT – 09/2006
WARNING
WARNING
CAUTION
14
Figure 10