OREC LS 280 Owner's Manual page 27

ASSEMBLE OF LS360
1. Put the handle into the bracket and tightens the bolt with the cap nut. Fix the both sides of the clutch
levers with the R pin.
2.Tie the handle of right side, side clutch wire and throttle wire ,switch harness with wire belt.
Then, tie the handle of left side, side clutch wire, running clutch wire, brake wire, with the wire belt.
(Refer to fig.1)
WARNING
The wire, switch harness should not touch to the Muffler, Exhaust gas and other moving
part(crawler ,Belt).
Do not strain the side clutch wire, or the lever.
After assembling, rise and lower the platform and check if the wire does not disturb the operation.
If the wire disturb, it may cause the damage of the wire and serious injury, as the platform is not locked
completely.
After checking, lower the platform surely.
fig.1
Wire should not touch the crawler
ASSEMBLE OF LS461
© SAT – 09/2006 27