Yamaha X-MAX 300 Owner's Manual page 74

Periodic maintenance and adjustment
1. Oil filter element
2. O-ring
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
Tightening torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.2 lb·ft)
TIP
7
Make sure that the O-ring is properly
seated.
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 14 lb·ft)
9. Refill with the specified amount of
the recommended engine oil.
Recommended engine oil:
See page 9-1.
Oil quantity:
Oil change:
1.50 L (1.59 US qt, 1.32 Imp.qt)
With oil filter removal:
1.60 L (1.69 US qt, 1.41 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
1
parts after the engine and exhaust sys-
tem have cooled down.
Make sure that no foreign material
2
enters the crankcase.
10. Install and tighten the oil filler cap
11. Start the engine, and then let it idle
12. Turn the engine off, and then
7-11
NOTICE
and its O-ring.
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
check the oil level and correct it if
necessary.
ECA24060