Handlebar Switches - Yamaha X-MAX 300 Owner's Manual

Instrument and control functions

Handlebar switches

Left
1
2
3
1. Dimmer/Pass switch "
4
2. Turn signal switch "
3. Horn switch "
Right
1. Stop/Run/Start switch "
2. Hazard switch "
3. "TRIP/INFO" switch
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
/ /PASS"
/ "
"
1
2
3
/ / "
"
/ /PASS"
" for the high
" for the low beam.
/ "
". To signal a left-hand
". When
EAU1234M ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards " ". See
page 6-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the main switch in the "ON"
or " " position, use this switch to turn
on the hazard lights (simultaneous
flashing of all turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
EAU54201
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
"TRIP/INFO" switch
EAU12461
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 4-3 for more in-
formation.
4-12
EAU12501
"
EAU54212
/ / "
", and then push
" to stop the en-
EAU78190
ECA10062
EAU78491