Omron CJ2-CPU Connection Manual page 60

22
In the PLC Memory Window of
CX-Programmer, check that the
value of D10104 is as shown below.
D10104
Bits 0 to 7: 4 (dec)
Bits 8 and 9: 00 (bin)
*For details on each of the
addresses, refer to 6.4. Tag Data
Link Settings.
*You can check that the monitor
output (Detection Level) of Port 1 is
4 and that the control outputs 1
and 2 are OFF; these values are
the same as the ones described in
step 21.
23
Place Sensing object in front of
Photoelectric Sensor and check that
Operation indicator is lit in orange.
24
Check that the values of
Photoelectric Sensor in
CX-ConfiguratorFDT are as shown
below.
Detection Level: 255
Control Output 2: ON
Control Output 1: ON
*The value of the detection level
differs depending on the
environmental settings of
Photoelectric Sensor.
7．IO-Link Connection Procedure
D10104
Bits 0 to 7 : 04 (hex) → 4 (dec)
Bits 8 to 15 : 00 (hex) → 00000000 (bin)
(Check that the bits 8 and 9 are 0.)
Sensing
Operation indicator
object
<Top view of Photoelectric Sensor>
↑
57