Omron CJ2-CPU Connection Manual page 24

7.2.4. IO-Link Master Unit Setup
Set the parameters for IO-Link Master Unit.
In this document, the default values are used for the parameter settings of IO-Link Master Unit.
Check that IO-Link Mode is set as the communications mode for Port 1 to which Photoelectric
Sensor is connected.
Additional Information
If you use the functions such as the connected device verification and the backup and
restoration of parameter settings in IO-Link devices, refer to the NX-series IO-Link Master
Unit User's Manual (Cat. No. W567) and the IO-Link System User's Manual (Cat. No. W570).
1
Select the device icon of IO-Link
Master Unit (NX Unit number 1)
on the EIP : NX-EIC202
(Master) Tab Page.
Click Edit Unit Operation
Settings.
2
The Unit 1 [EIP]:NX-ILM400(N1)
Unit Operation Settings Tab
Page is displayed.
3
▼
Select Port1 - Port1 IO-Link
Device Configuration Data
from the pull-down list (just
above the column "Item name")
to narrow down the parameters.
7．IO-Link Connection Procedure
21