User-Programmable Leds - GE T35 Instruction Manual

PRODUCT SETUP
subsequent triggers and continues to record data until the active record is full. Once the data logger is full, a CLEAR DATA
LOGGER command is required to clear the data logger record before a new record can be started. Performing the CLEAR
DATA LOGGER command also stops the current record and resets the data logger to be ready for the next trigger.
DATA LOGGER TRIGGER
operand can be used as the trigger source. This setting only applies when the mode is set to "Trigger."
DATA LOGGER RATE
DATA LOGGER CHNL 1(16)
log. The parameters available in a given relay are dependent on: the type of relay, the type and number of CT/VT hardware
modules installed, and the type and number of Analog Input hardware modules installed. Upon startup, the relay
automatically prepares the parameter list. A list of all possible analog metering actual value parameters is shown in
Appendix A: FlexAnalog Parameters. The parameter index number shown in any of the tables is used to expedite the
selection of the parameter on the relay display. It can be time-consuming to scan through the list of parameters via the
relay keypad/display—entering this number via the relay keypad causes the corresponding parameter to display.
DATA LOGGER CONFIG
selected to "Off" without overwriting old data.

5.3.11 User-programmable LEDs

5.3.11.1 Menu - Enhanced and standard front panels
SETTINGS  PRODUCT SETUP  USER-PROGRAMMABLE LEDS
 USER-PROGRAMMABLE
 LEDS
5
5.3.11.2 Menu - Graphical front panel
SETTINGS  PRODUCT SETUP  USER-PROGRAMMABLE LEDS
 USER-PROGRAMMABLE
 LEDS
The LEDs can be customized to illuminate when a selected FlexLogic operand is in the logic 1 state. The trip and alarm
LEDs can also be customized in a similar manner. To ensure correct functionality of all LEDs, an LED test feature is also
provided.
5-118
— This setting selects the signal used to trigger the start of a new data logger record. Any FlexLogic
— This setting selects the time interval at which the actual value data is recorded.
— This setting selects the metering actual value that is to be recorded in Channel 1(16) of the data
— This display presents the total amount of time that the Data Logger can record the channels not
 LED TEST


 TRIP & ALARM LEDS


 USER-PROGRAMMABLE

 LED 1
 USER-PROGRAMMABLE

 LED 48
 LED TEST


 TRIP & ALARM LEDS


 EVENT CAUSE LED 1


 EVENT CAUSE LED 9


See below
See page 5-121
See page 5-121

See below
See page 5-121
See page 5-122

T35 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS