GE T35 Instruction Manual page 395

CHAPTER 5: SETTINGS
A FlexElement is a universal comparator used to monitor any analog actual value calculated by the relay or a net
difference of any two analog actual values of the same type. The effective operating signal can be treated as a signed
number or its absolute value can be used.
FlexElements run every half power cycle (every four protection passes).
The element can be programmed to respond either to a signal level or to a rate-of-change (delta) over a pre-defined period
of time. The output operand is asserted when the operating signal is higher than a threshold or lower than a threshold, as
per your choice.
T35 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
FLEXELEMENT 1 INPUT

MODE: SIGNED
FLEXELEMENT 1 COMP

MODE: LEVEL
FLEXELEMENT 1

DIRECTION: OVER
FLEXELEMENT 1

PICKUP: 1.000 pu
FLEXELEMENT 1

HYSTERESIS: 3.0%
FLEXELEMENT 1 dt

UNIT: Milliseconds
FLEXELEMENT 1 dt:

20
FLEXELEMENT 1 PKP

DELAY: 0.000 s
FLEXELEMENT 1 RST

DELAY: 0.000 s
FLEXELEMENT 1 BLK:

Off
FLEXELEMENT 1

TARGET: Self-reset
FLEXELEMENT 1

EVENTS: Disabled
Range: SIGNED, ABSOLUTE
Range: LEVEL, DELTA
Range: OVER, UNDER
Range: –90.000 to 90.000 pu in steps of 0.001
Range: 0.1 to 50.0% in steps of 0.1
Range: Milliseconds, Seconds, Minutes
Range: 20 to 86400 in steps of 1
Range: 0.000 to 65.535 s in steps of 0.001
Range: 0.000 to 65.535 s in steps of 0.001
Range: FlexLogic operand
Range: Self-reset, Disabled, Latched
Range: Disabled, Enabled
FLEXLOGIC
5
5-193