Clock And Alarms - Sangean BTR-160 Manual

Disconnecting your Bluetooth device
Press and hold the Bluetooth pairing button for 2-3 seconds to disconnect with your Bluetooth
device. You can also press the Mode button and rotate the Tuning Control Rotary to select any
mode other than Bluetooth mode and then press the Tuning Control Rotary or turn off Bluetooth
on your Bluetooth source device to disable the connection.
If you disconnect the Bluetooth device when you are in Bluetooth mode, the "Pairing" will show
on the display, indicating Bluetooth is available again for pairing.

Clock and Alarms

Automatically updating the clock
You may specify that the radio sets its clock from DAB or FM radio broadcasts. After a power
failure the radio will then set its clock the next time that you turn on the radio in DAB or FM mode.
Alternatively you may specify that the time is not automatically updated. In this case the clock
must always be set manually after a power interruption.
1. With your radio switched on, press the Menu button to access the menu for the current mode.
2. Rotate the Tuning Control Rotary until 'System settings' is highlighted on the display. Press
the Tuning Control Rotary to enter the system settings menu.
3. Rotate the Tuning Control Rotary until 'Time/Date' is highlighted on the display. Press the
Tuning Control Rotary to enter the time setup.
4. Rotate Tuning Control Rotary until 'Auto update' is highlighted on the display. Press Tuning
Control Rotary to enter the auto-update menu.
5. Rotate the Tuning Control Rotary to choose an update option from 'Update from DAB',
'Update from FM', or 'No update' as required. Press the Tuning Control Rotary to confirm
your choice. The radio will then exit to the previous menu display.
System settings
Backlight
Equaliset
Time/Date
1
Inactive Standby
Language
Time/Date
Set Time/Date
Auto update
Set format
2-5
Auto update
Update from DAB
Update from FM
No update
GB
>
>
>
>
>
*
23