Page 4
FUNCTION BUT/SW MARKING POWER PWR. ON/OFF/ALARM OFF/SLEEP FUNCTION DAYLIGHT SAVINGS TIME SWITCH DISPLAY LIGHT TIME SET BAND MANUAL TUNING/ USB/LSB STEP Step 9KHz 9/10KHz 1KHz 5KHz Fast 100KHz 1KHz 1KHz 40KHz 50KHz 1KHz Slow TIMER SLEEP TIMERS (1,2,3) MODE SELECT MODE (SELECTS USB/LSB/AM AND WAKE-UP ALARMBY RADIO OR HWS BUZZER HOME/WORLD TIME SELECTION WORLD...
Page 5
ENTER SELECTION/0 Secretary. TIME SET SELECTION CANCE/11 M SELECT DIGIT INPUT/CLOCK/MEMORY & SW BAND DECIMAL POIN/SW 15 METER BAND METER/SW SELECTS SW BAND ATS/MW SELECTS MW BAND/PRESETS ALL STATIONS SELECTS FM BAND/PRESETS ALL STATIONS ATS/LW SELECTS LW BAND/PRESETS ALL STATIONS ATS/FM AM RF GAIN ADJUSTS LEVEL OF INCOMING SIGNAL TO PREVENT OVERLOAD AND DISTORTION...
Page 6
d. SNOOZE ICON e. SLEEP TIMER ICON TIMER g. RADIO WAKE-UP h. HWS BUZZER WAKE-UP i. SELECTED TIMER BATTERY SYMBOL ICON k. SIGNAL/BATTERY LEVEL ROTARY TUNING SPEED m. STATION/CITY n. FREQUENCY o. RDS SYMBOL p. FM STEREO INDICATOR q. MEMORY LOCKED r.
Mean Time). The clock can be set with the power on or off. The clock display will start to run as soon as batteries are inserted. Press button (4) (Time Set).Display time digit will be blank and Home display will flash. Use digital buttons (19) to enter the actual time in hours.and minutes.(Don't forget time must be entered on a 24 hour basis).Once entered,hours and minutes will be displayed in display.
Page 8
T U N I N G M E T H O D S T h i s r e c e i v e r o f f e r s 5 m e t h o d s o f f r e q u e n c y t u n i n g : AT S - A u t o T u n i n g T h i s s y s t e m a u t o m a t i c a l l y s e t s y o u r m e m o r y p r e s e t s b a s e d u p o n t h e s i g n a l...
The Step button (5) is used to determine the tuning spread for each step of the Rotary Tuning Knob. Spread may be changing accordingly: BANDS USB/LSB STEP 9 KHz 5 KHz 100 KHz 9/10 KHz 1 KHz Fast Slow 50 KHz 1 KHz 1 KHz 1 KHz...
Space in the LCD Display. Once a character is selected you may move to the next position to place another character by using the UP/DOWN button (10).When name is completely entered press button. RECALLING A STATION IN MEMORY On LW, press ATS/LW button (23),then press any of the numbered buttons on the key pad. On MW/FM, press A TS/MW button (22) [MW] or press A TS/FM button (24),select desired page by pressing page button(11)[PAGE] and then press any of the numbered on the key pad.
Simply pressing one button. To program the Direct button recall your favorite station, press MEMO button (16) [M] and then press PRIORITY button (13) [ ALARM FUNCTION The ATS-909 has three timer circuits as indicated by TIMER button (6) [1] [2] [3]. The alarm function may be set with the power on or off.
Instructions. 6] You may also scan the band for SSB stations by slowly rotating the Rotary Tuning Knob [31] through the selected band, tuning for the best intelligibility and watching for deflections on the Signal Strength Indicator [k] in the display. (SSB transmit with a "suppressed carrier" meaning the Signal Strength Indicator [k] in the display will fluctuate only when there is a voice transmission and not during pauses in voice transmission.
ANT-60 PORTABLE SW ANTENNA Included with the A TS-909 is the Sangean ANT-60 Portable SW Antenna. The antenna is plugged into jack (26) labeled EXT AM ANT. When fully extended this antenna should improve SW reception. For maximum performance this antenna should be placed as high as possible above the ground and in an unobstructed area if possible.
Page 14
5.900-6.200 7.100-7.350 9.400-9.990 11.600-12.100 13.500 13.870 15.100 -15.800 17.480-17.900 18.900-19.020 21.450-21.750 25.600-26.100 BATTERIES 4x1.5 Volt (AA) External Power Supply: 6.0VDC/300mA/Negative Polarity Center Dimensions in inches: (WxHxD): 8 1/4x5.0x1 1/2 Weight in oz: 30...