Presetting Stations In Dab And Fm Modes; Recalling A Preset In Dab And Fm Modes - Sangean BTR-160 Manual

Presetting stations in DAB and FM modes

There are 5 memory presets each for DAB and FM radio. They are used in the same way for
each operating mode.
1. Press the Standby button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press and hold the required Preset button (1-5) until the
display shows 'Preset stored'. The station will be stored under the chosen preset button.
Repeat this procedure as needed for the remaining presets.
4. Stations which are already stored in the presets may be over written by following the above
procedure.
Note:
The radio station presets are retained in memory when the radio is switched off and disconnected
from the mains supply.

Recalling a preset in DAB and FM modes

1. Press the Standby button to switch on your radio.
2. Select the required operating mode.
3. Momentarily press the required Preset button. Your radio will then tune to the station stored in
the selected preset memory. The chosen preset number is also shown in the lower area of the
radio display, e.g. ' ★ 4'.
20
Preset stored
FM 00:00
106.00 MHz
FM Radio
4