When The Alarm Sounds; Disabling Alarms - Sangean BTR-160 Manual

When the alarm sounds

The buzzer or radio alarm will sound at the selected times for up to 60 minutes unless cancelled.
The volume used for the alarm will be as specified during the alarm setting procedure. If the
radio cannot connect to the specified radio station, the buzzer alarm will be used instead. To
cancel an alarm, press the Standby button to return to standby mode. The alarm icon will flash at
the bottom of the playing mode displays, and the radio will automatically switch back to standby
mode when the 60 minutes have elapsed.
Note:
If you have your earphone insert while the alarm is sounding, the sound of the alarm will come
out from your earphone.

Disabling alarms

1. To disable a single alarm enter the alarm setup menu and rotate the Tuning Control Rotary
until the desired alarm is highlighted on the display. Press the Tuning Control Rotary to
confirm.
2. Rotate the Tuning Control Rotary until the 'Enable:' option is highlighted on the display. Press
the Tuning Control Rotary.
3. Rotate the Tuning Control Rotary to highlight 'Off' and press the Tuning Control Rotary.
4. Rotate the Tuning Control Rotary until the 'Save' option is highlighted on the display then
press the Tuning Control Rotary to save the new setting. The chosen alarm will now be
disabled.
28
Alarms
Alarm 1: On [07:30]
Alarm 2: Off [00:00]
1
Buzzer
1
Alarm 1
Enable:Off
Time: 07:30
Mode: Buzzer
1-4
Volume: 20
Save
17:31