Printer Components: Transfer Roller - Fargo HDP5000 User Manual

RESTRICTED USE ONLY

Printer Components: Transfer Roller

Danger: The Printer's Transfer Roller can reach temperatures exceeding 350
degree F (175 C). Use extreme caution when operating the Transfer Roller. Never touch
the Transfer Roller unless the Printer Power has been turned off for at least 20 to 30
minutes.
Type Description
Controls Both the Printer itself and the Printer's software Driver control the
built-in Transfer Roller.
Temperature To change the temperature of the Transfer Roller, adjust its
Adjustment temperature through the Image Transfer Tab within the Printer Driver
setup window.
Once adjusted, the new temperature settings will be sent down with
the next print job along with the rest of the Printer Driver information.
New Before printing begins, the Transfer Roller will automatically adjust
itself to the new temperature setting. (Note: This new temperature
Temperature
Setting setting will remain programmed within the Printer until it is once again
changed within the Printer Driver or until the Printer is turned OFF.)
Whenever the Printer is turned OFF, the Transfer Roller will
automatically reset itself and return to its default temperature the next
time the Printer is turned ON.
Disconnect the Printer's power supply. (Technician Note: Cycling
the Printer's power supply serves to reset the Transfer Roller to its
default temperature. The temperature setting within the Printer Driver,
however, will stay the same until it is changed.)
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.5)
Fargo Electronics, Inc.
24