Choosing A Good Location; About Moisture Condensation; Packing The Card Printer For Transport - Fargo HDP5000 User Manual

RESTRICTED USE ONLY

Choosing a Good Location

Follow these guidelines:
•
Place the unit in a location with adequate air circulation to prevent internal heat build-
up.
•
Use the Printer's dimensions as a guideline for the minimum clearances to the unit.
(Note: Allow for adequate clearance above the unit to accommodate the height of
the unit with its Covers open.)
•
Do not install unit near heat sources such as radiators or air ducts or in a place
subject to direct sunlight, excessive dust, mechanical vibration or shock.

About Moisture Condensation

If the unit is brought directly from a cold to a warm location or is placed in a very damp
room, moisture may condense inside the unit. Should this occur, print quality may not be
optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will
allow the moisture to evaporate.
Caution: For safety purposes, Ethernet is not intended for a direct connection
outside of the building.

Packing the Card Printer for transport

The purpose of this section is to provide the User with a specific packing procedure for
the HDP5000.
(Note: Do not install the Lamination Module to the Printer before shipping. The
Lamination Module must be packaged in its own box and shipped separately, then
installed at the site. Attaching both modules together before shipping may cause
damage.)
Follow this instruction to pack the Card Printer for transport.
Step Procedure
1 Clean the inside of the Printer with deionized air. Wipe it down with a lint-free
cloth.
2 Clean the Printhead with a Printhead swab.
3 Pack the Printer in the original carton and packing materials.
4 Be sure to enclose any necessary paperwork, test cards, etc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.5)
Fargo Electronics, Inc.
30
Formatted: Bullets and Numbering