Connecting the oil-filled roughing pump
Note:
To connect the alternative dry roughing pump, see
Exhaust port flange
Oil filler plug
Oil-level sight glass
Drain plug
Required materials:
•
Chemical-resistant, powder-free gloves
•
7-mm nut driver
•
8-mm Allen wrench
•
Sharp knife
•
NW25 tee (included in the installation kit)
•
NW25 center rings (included in the installation kit)
•
NW25 clamps (included in the installation kit)
•
10-mm reducer fitting (included in the installation kit)
•
10-mm ID nylon tube (included in the installation kit)
•
PVC exhaust tubing (included in the Waters Rough Pump Connect Kit)
•
PVC hose clamps (included in the Waters Rough Pump Connect Kit)
•
1-inch ID vacuum hose (included in the Waters Rough Pump Connect Kit)
Connecting the oil-filled roughing pump
page
238.
Gas ballast valve
January 11, 2016, 715004599 Rev. B
233