Llrp Communications Protocol - Motorola fx7400 Integrator Manual

LLRP Communications Protocol

From the
Administrator Console
window appears
Settings
LLRP is not active unless the changes are committed by clicking
commit activates LLRP. By default, LLRP activates in server mode listening on port 5084.
NOTE When the reader operates in LLRP server mode, LLRPConnect does not appear on the web page. Only
DisconnectLLRP appears (it is greyed if there is no LLRP client connected to the reader). DisconnectLLRP
and ConnectLLRP are mechanisms to connect the reader to an LLRP client or disconnect the reader from an
LLRP client. When the reader is operating in LLRP Client mode, the ConnectLLRP is enabled to allow
connection to the LLRP host. Once connection is successful in this mode, the DisconnectLLRP is enabled to
allow disconnecting from the host.
Configure LLRP Settings Window
Figure 4-22
The
LLRP Service Settings
state (running or not running) appears next to the LLRP Status.
LLRP-specific configuration parameters are separate from other parameters related to communications. The
configurable LLRP parameters are listed in
(see Figure 4-1 on page
(Figure 4-22). To be compatible with older releases, LLRP is not enabled by default.
Window provides LLRP Status and specific LLRP configuration parameters. The current
Table 4-2.
Administrator Console 4 - 21
4-1) click >
Communication
on the
Commit Commit/Revert
. The
LLRP Configure LLRP
page. A successful