Powering The Reader; Verifying Hardware Functionality - Motorola fx7400 Integrator Manual

Antenna Ports (Reverse TNC)
FX Series RFID Reader Antenna Connection
Figure 3-2

Powering the Reader

Connect the antennas before supplying power to the reader.
CAUTION
To power the reader:
Insert either the POE Ethernet connector or the power supply barrel connector into the appropriate reader
1.
power (see Figure 2-4 on page
Apply power to the power supply. The green Power LED stays on to indicate the reader is powered and ready.
2.
See System Start-up/Boot LED Sequence on page
To power down the reader:
Unplug the power supply from its power source to remove power. The green Power LED turns off to indicate
1.
that the device is off and the system is not operational.
Remove the connector from the reader power port.
2.
AC Power Supply
The Motorola approved AC power supply connects to the power port on the FX Series reader using a locking
connector (see Figure 2-4 on page
•
120V 60 Hz (North America)
•
230V 50 Hz (International excluding Japan)
•
100V 50/60 Hz (Japan).

Verifying Hardware Functionality

System Start-up/Boot LED Sequence
See Figure 2-5 on page 2-6
All LEDs turn green.
1.
All LEDs turn off and the PWR LED turns red.
2.
The PWR LED turns off and then turns green.
3.
When the sequence completes the green PWR LED remains on and all other LEDs are off.
4.
2-5). Rotate the power supply barrel connector to lock the connector in place.
2-5). The power supply is compatible with:
for LED locations. During system start-up:
Installation and Communication
Rear Panel
3-5.
3 - 5